Decision C(2025)129 of 20.1.2025 - Mandate M/605 (Standards for Machinery Regulation)
Decision C(2025)129 of 20.1.2025 - Mandate M/605 (Standards for Machinery Regulation)
Commission implementing decision of 20.1.2025 on a standardisation request to the European Committee for Standardization and to the European Committee for Electrotechnical Standardization as regards machinery and related products in support of Regulation (EU) 2023/1230 of the European Parliament and of the Council.
__________
Article 1 Requested standardisation activities
1. The European Committee for Standardization (‘CEN’) and the European Committee for Electrotechnical Standardization (‘CENELEC’) are requested to draft new harmonised standards and European standardisation deliverables listed in Table 1 of
Annex I to this Decision and to amend or revise the existing harmonised standards and European standardisation deliverables listed in Table 2 of Annex I to this Decision, in support of Regulation (EU) 2023/1230, for machinery, related products and partly completed machinery by the deadlines set out in that Annex.
2. If CEN and CENELEC do not amend or revise the harmonised standards referred to in Annex I to Commission Implementing Decision (EU) 2023/1586, they shall, by 20 January 2026, inform the Commission of the references of those standards and, where relevant, of the reasons why their amendment or revision is not under preparation.
3. The harmonised standards and European standardisation deliverables referred to in paragraph 1 shall meet the requirements set out in Annex II.
4. CEN and CENELEC shall provide the Commission with the titles of the requested harmonised standards in all the official languages of the Union.
[...]
Article 4 Validity of the standardisation request
1. Where, in accordance with Article 10(3) of Regulation (EU) No 1025/2012, CEN or CENELEC indicate that they do not accept the request referred to in Article 1(1) of this Decision, that request shall not constitute a basis for the standardisation activities
referred to in Article 1(1) of this Decision for the standardisation organisation concerned.
2. This Decision shall expire on 20 January 2035.
Article 5 Expiry of existing standardisation mandates
Standardisation mandates M/396 of 19 December 2006 and M/471 of 29 June 2010 shall expire on 20 January 2027.
...
Vedi Mandato
- Published: 29 May 2026
- Hits: 30
